uControl Remote will work with any HDA system marked “uControl inside”. These are typically MHUB’s, MZMA or uControl Zone Processors which shipped with uControl OS (uOS) version 10 or above. MHUB’s which were installed with MHUB-OS (MOS) will not support the uControl Remote, but some can be upgraded (see below).
Supported Stacked Systems
REQUIRES A UCONTROL ZONE PROCESSOR 1
| List of systems that support uControl Remote | ||
|---|---|---|
Natively Supported |
||
| MHUB (4×1+1) 40 (uOS 11.xx) | ||
| MHUB (4×4) 100A (uOS 11.xx) | ||
| MHUB (6×6) 100A (uOS 11.xx) | ||
| MHUB S (8+8×8) 100A (uOS 11.xx) | ||
| MHUB S (16+16×16) 100A (uOS 11.xx) | ||
| MZMA (6×4) 55 (uOS 11.xx) | ||
| uControl Zone Processor 1 | ||
| uControl Zone Processor 5 | ||
| uControl Connect Processor | ||
UpgradableREQUIRES A UCONTROL ZONE PROCESSOR |
||
| MHUB PRO 2.0 (4×4) 40 | ||
| MHUB PRO 2.0 (8×8) 100 | ||
| MHUB PRO 2.0 (4×4 & 8×8) & MZMA | ||
| MHUB S (100A) & MZMA | ||
| MHUB S (100) + MHUB S (100A) | ||